How to in stall Nerf Stryfe Worker kriss vector Modified Kit Blaster

How to in stall Nerf Stryfe Worker kriss vector Modified Kit  Blaster 

Tool Needed:

• Small Phillips-Head Screwdriver

• Small Flat-blade Screwdriver

Step 1:
Remove all the screws on the blaster and beware keeping the screws in box

Step 2:

Remove all the screws on the upper halve, locate the magazine catch module and remove the screws as shown. 

Step 3:
Pick up the magazine catch module in safe position.

Step 4:
Pick the magazine catch piece and replace the spring coil with Worker Nerf spring coil
as include in the package. Install the catch back to the nerf stryfe blaster.

Step 5:
Replace and install the releaser by Worker push button piece, fasten the screws
and make sure the magazine catch module secure on the blaster. Cover the halve shell  and fasten

Step 6:

Step 7:

Step 8:
Hold the Kriss Vector Housing, install the rail on the top front body, sightly install
and slide into Stryfe front bottom rail.

Step 9:
Push the Housing to the end of rail, check if complete install fitting the outer structure of
Stryfe

Step 10:
Locate the tail end of the parts, push and fit into Strfye grip button as shown. Secure in
position with the pin snap into the hold of the tail.

Step 11:
Install the muzzle cap onto Stryfe, simply put the cap into the muzzle rail and snap fit by
anti-clockwise turning.

Step 12:

Step 13:

The Worker nerf Kriss Vector Magazine,capacity 6rd, please
notice the pattern at the botton.

Step 14:

Unfasten the screws on the top of the Kriss Vector Magazine Adaptor.

Step 15:

Install the Worker nerf Kriss Vector Magazine onto the 6 Darts Magazine, please notice the direction
and fit onto the emboss pattern.

Step 16:

Fasten the screws and check complete closure, load the soft darts and go for Kriss
Vector Nerfbattle!